A brief analysis of common failures and maintenance measures of automatic sealing machine

Shantou heptyl kun packaging machinery factory co., LTD is a professional production and sales of conventional filling seal equipment/self-supporting bag cap unscrewing machine, frozen sucker filling sealing machine and other products, the products sell well in more than 30 domestic provinces and cities and southeast Asia, the Middle East, Africa and other regions. Automatic sealing machine is one of its products, and it is a more common kind of sealing machine.

Automatic sealing machine automatic production, high production efficiency, product quality is good, and in the process of production operation, hard to avoid can appear a little fault can lead to sealing machine can't work normally, affect the sealing quality. The following are the common failures and maintenance measures of automatic sealing machine for the nature packaging machinery factory.

Automatic sealing machine common failures and maintenance measures

Stop and stop the automatic sealing machine

Cause: the joint of the shaft lever of the motor and transmission joint appear fall off or flabby phenomenon/motor carbon brush wear serious, leading to the carbon brush and slip ring can't contact or friction performance is bad.

Repair - tighten screws to fit all/replace the same type of carbon brush.

2. The sealing temperature is out of control

Performance phenomenon: as the thermometer display failure, unable to control temperature, heat sealing temperature is not constant, pincer-like device is often burned or sealing and the phenomenon of not firm, seal deformation, is not beautiful.

Cause - the temperature of the thermometer is not good, the heat seal is not good, the heat sealing coefficient is changed, and the temperature is inconsistent.

Maintenance measures - replace the thermometer/replace hot spot coupling/reheat seal pressure until appropriate/change hot seal material.